ELEVATE RMA STRIP PLM

ELEVATE QuickSeam R.M.A. Strip

Description

Elevate’s QuickSeam R.M.A. Strip is a 254 mm (10”) wide, non-dusted strip of RubberGard MAX Reinforced EPDM membrane with two 76 mm (3”) wide QuickSeam tape strips factory laminated to it along both edges. The strip is used for non-penetrating RubberGard EPDM membrane attachment as specified in the Elevate specifications and details.

Preparation

The substrate needs to be clean, smooth, dry and free of sharp edges, loose or foreign materials, oil, grease and other materials that may damage the material. Restore to room temperature prior to use, if exposed to temperatures below 15°C for prolonged periods.

Application

Unroll the QuickSeam R.M.A. Strip with the release paper up in accordance with the layout plan specified. Once the strip lays flat, fasten it to the substrate with Elevate Batten Strips or approved plates and fasteners (max. 250 mm o.c.) and install the RubberGard EPDM membrane as specified in the Elevate specifications and details.

Coverage

In accordance with length of mechanical attachment.

Characteristics

Packaging / Storage / Shelf Life

Packaging: 30.5 m (100’) rolls, 1 roll per carton.

Note: QuickScrubber and/or QuickScrubber Plus pads and handles are included in each carton. Quantities vary depending on the QuickSeam product.

Storage: Store in original unopened containers at temperatures between 15°C and 25°C. Keep the material out of direct sunlight until ready for application.

Shelf Life: 12 months can be expected if stored in above-mentioned conditions. Shelf life information is only a recommendation and not a fact of life. The real expiration date highly depends on the history of storage and handling of the accessories. Quality and applicability should thus always be verified: QuickSeam R.M.A. Strip can be used only as long as the release paper can easily be removed from the tape without tearing the paper apart.

Precautions

Refer to Material Safety Data Sheets.