QUICKSCRUBBER PAD
Used to apply Quickprime Plus to rubber membrane. It applies the primer at the same time as it cleans the membrane.
METHOD OF APPLICATION:
Install a QuickScrubber pad on the bottom of the handle (available here) by pressing the pad onto the industrial grade Velcro surface with firm hand pressure. Use back and forth strokes with heavy pressure along the length of the splicing area, until membrane surfaces become dark gray in color with no streaking or puddling.
Bear down on the QuickScrubber pad during application to ensure the total surface is in contact with the priming surface. Each pad will prime about 30.5 m - 61.0 m (100.0’ - 200.0’) by 152.4 mm - 177.8 mm (6.0" - 7.0”) wide area. Change pads routinely. Do not attempt to turn pads over and re-use: discard after 30.5 m - 61.0 m (100.0’ - 200.0’) of priming.
Note: Additional application instructions on the use of QuickPrime Plus and QuickScrubber can be found on the QuickPrime Plus Technical Information Sheet and in Firestone’s PondGard Technical Specifications Manual.
skylight options | N/A |
---|
-
Mick Bond
2019-12-01 13:03:38
Is this part of the recommended accessories for flat roof kits or is it in the kit please?
1 answer-
Permaroof Team
2019-12-01 13:54:49
Hi Mick, thanks for your question.
The Quickscrubber pad is not included in the standard kits, but can be included in a tailored, bespoke flat roof kit. Please contact a member of the EPDM products team to discuss your requirements on 01773 441947, they'll be happy to chat this through with you.
Hope this helps, thanks again.
-
-
This Item:
QUICKSCRUBBER PAD
£1.40 £1.17
-
UPVC BOND & SEAL SEALANT (BLACK)
£3.59 £2.99
-
FIRESTONE 3 SEAM TAPE PLM
£6.78 £5.65
-
SILICON RUBBER ROLLER
£23.04 £19.20
-
Firestone Spray Adhesive-0.75L
£13.18 £10.98
-


