How to Fit the Gutter Edge Trim Backplate
|
The gutter edge trim system has been designed to complete the seal and sandwiches the membrane in a two-part design. Once the backplate has been installed, the membrane installation can be completed, before returning to install the top gutter edge piece. In this guide, we will show you how to install the gutter edge backplate. Note that this trim system is best installed alongside the rubber roofing and the backplate ideally installed first, before the final EPDM adhesion at the gutter edge. What you will need:
Buy all the products you need securely online with fast UK delivery at PermaRoof Store. Give the team a call if you need any further help with your order or installation. |
Ensuring a completely watertight seal adds to the longevity of your roofing, so using a good quality trim system is crucial. How to Fit the Gutter Edge Trim Backplate
Step 1
Remove any EPDM membrane that is overhanging the cutting edge and fold it back over itself onto the roof deck.
Step 2
Temporarily place the gutter edge back plate in position, to put the screws in, just to start them off. There is a recess in the backplate that will allow the screws to go in. The spacing on these screws are approximately 400mm.
Step 3
Once you’ve got all the screws in place, just offer the backplate over the side, making sure that the top edge of the backplate does not protrude higher than the level of the roof deck.
Step 4
Now nip the screws up securely to make sure that the backplate stays in position. Now continue with the EPDM rubber roof installation.
Buy the two-part gutter edge trim system
Part two of the installation guide - How to Fit the Gutter Edge Trim Drip Plate
More guides from PermaRoof UK
PermaRoof UK offers support to both trade and DIY for EPDM application. We provide a further range of installation guides, datasheets, product and technical information in the Knowledge Base and in our corporate resource library here.
Watch the installation guide video on YouTube >
Become an expert with our EPDM training days
We run accredited EPDM training days for both sheet membrane application and liquid waterproofing. Training days are held at the PermaGroup headquarters in Derby at our purpose-built, approved training centre. Intensive, one-day courses and certification.