ELEVATE 9 INCH FORMFLASH PLM

 


ELEVATE's 9" Formflash is designed to flash inside and outside corners, pipes, penetrations, drain outlets and any other awkward details.

At 1m x 229mm ELEVATE 9" Formflash consists of a 229mm uncured Formflash, factory laminated to Quickseam Tape.  

Preparation

The EPDM surfaces must be dry, clean, free from dust and be prepared with ELEVATE Quickprime Plus, using a Quickscrubber pad. Use of other products is not allowed. Restore the product to room temperature prior to use if exposed to temperatures below 15 degrees for prolonged periods.

Application

On cloudy days with ambient temperature below 15 degrees, the use of a heat gun is recommended to warm the Formflash and to ensure good formability. On sunny days, pre-heating of the product is usually not necessary.  Apply Quickprime Plus to all areas to receive the Formflash using a Quickscrubber pad and Handle.  Allow the Quickprime Plus to completely dry before installing the Formflash, test for dryness by touching the Quickprime Plus with a clean dry finger.  Remove the backing paper and carefully apply the Formflash to the pipe, corner, or penetration etc.

Physical Characteristics

Excellent moisture resistance and excellent resistance to heat and cold.  Green tack Quickprime Plus must be used with this product!  Quickscrubber Pad and Handle.

Product code: 520291.

Quickprime Plus must be used with SA Flashing.

For further product information please do not hesitate to contact us.

Customer Service and Delivery

 

  • Orders placed before 2pm will usually be delivered the next working day (Mainland UK).
  • Collection available from Alfreton, Derby.
  • For further product information please do not hesitate to contact us.
  • Free installation guides available on request via e-mail or post.

 

Buy here

 

9 Inch Formflash